201601_boss_0139

THE BOSS Straight-Blades are the proven choice for professionals and homeowners alike. Built with an optimized blade curl that means snow rolls cleanly off the plow.  To maximize the efficiency of your straight blade use this how to guide for tips on using your BOSS Snowplow Straight Blade.

 

Angle-Position

In this position the blade is angled to either left or right side of the vehicle. Use this position for windrowing or widening after the first pass.

 

How to Windrow

With the blade angled to the left or right side of the vehicle, make consecutive passes--each time throwing the snow forward and to the side. This technique is useful to clear large areas such as parking lots.

 

Straight-Position

In this position the blade is positioned directly in front of the vehicle. Use this position for backdragging, removing a large windrow or cleaning up at the end of the job.

 

How to Backdrag

To remove snow from the edge of a building, raise the blade and drive forward to the building. Lower the blade, then back up while pulling the snow away from the building. You should backdrag only two or three truck lengths before turning around. You can then back into the cleared area and push snow forward. Your plow will be more effective when pushing snow than when backdragging over long distances.

At the end of the job, adjust the blade to the Straight-position and push snow directly ahead--cleaning up any spill off left from previous plowing.

 

Deep Snow

In deep snow raise the plow several inches off the ground to shear off the top layer. If you have a Power-V Plow, use the V-position for the first pass. Then change to the Scoop or Angle-position to widen things out. You should push just enough snow with each pass to get the job done efficiently without overloading your equipment. A good rule of thumb is to use a full blade width for two inches of snow or less, three quarters of the blade for four inches of snow and a half blade for six inches of snow or more.

 

Wet Snow

The best advice is this: Once you start, finish the job. Wet snow left in windrows overnight can freeze and turn into tank traps by morning.

 

Check out this how to video to see the BOSS Super Duty in action.



Leave a Reply


Related Posts

Emily Forstrom 18 March, 2024

Importance of Material Application

Mastering Material Application: A Key to Snow and Ice Contractor Success

Natalie Hackstock 03 June, 2021

How to Store and Remove a Straight Blade Plow from Storage

When deciding to become a straight blade BOSS plow owner, it is important to know how to properly…