1. Raise 
2. Lower 
3. On/Off Switch
4. Left Wing Out 
5. Right Wing Out
6. Left Angle
7. Right Angle
8. AUX 1
9. AUX 2
10. Left Wing In
11. Right Wing In

1. Raise 
2. Lower 
3. On/Off Switch
4. Left Angle
5. Right Angle
6. AUX 1
7. AUX 2

With the controller turned OFF, press and hold the POWER button for 5 seconds.

The controller will enter programming mode, and the center button will flash green or red while in this mode.

• Green: Express Raise Enabled
• Red: Express Raise Disabled

To enable or disable Express Raise, push the UP button to toggle to the setting that is preferred.

Turn the controller power OFF to save your configuration

With the controller turned OFF, press and hold the POWER button for 5 seconds.

The controller will enter programming mode, and the center button will flash green or red while in this mode.

• Green: Express Raise Enabled
• Red: Express Raise Disabled

While in programming mode, cycle through the AUX buttons by pressing AUX 1 or AUX 2 to select the desired setting. 

LED COLOR OPTIONS:

• BLUE LED: High Beam Toggle​
• MAGENTA LED: ClearBeam ON/OFF
• ORANGE LED: Warning Lights ON/OFF
• RED LED: Spreader ON/OFF​ (VBX+)
• No LED: No configurations assigned
  

Turn the controller power OFF to save your configuration.

If one AUX button is configured to the warning lights (orange LED), the warning light pattern can be selected in the programming mode.

Refer to the steps below:

With the controller turned OFF, press and hold the POWER button for 5 seconds.

The controller will enter programming mode, and the center button will flash green or red while in this mode.

• Green: Express Raise Enabled
• Red: Express Raise Disabled

While in programming mode, press the DOWN button. The two AUX buttons will begin to flash in a pattern.

Press the UP button to cycle through the flash patterns. Stop on the desired pattern​.

Turn the controller power OFF to save your configuration.

NOTE: The settings will be saved until this procedure is repeated.